Skip to content
← All FAQs

How do you reset a water heater when it stops working?

To reset a water heater that stops working, safely restore power and use the unit’s reset or relight the pilot using the instructions on its label. Most shutdowns come from a tripped high-limit switch (electric) or an extinguished pilot/lockout (gas). A reset that won’t hold points to a fault, not a setting. We help homeowners across the Gas City area when a simple reset doesn’t last.

Try these focused steps:

  • Electric tank: turn the breaker off 10 seconds; remove the upper panel; press the red reset on the thermostat; replace the cover; turn power on; wait 30–60 minutes.
  • Gas tank: set the gas control to Off; ventilate; follow the door label to relight the pilot or reset; set to On/Hot; confirm the status light shows normal.
  • Stop and call if you see leaks, smell burning, the reset trips again, or hot water discharges from the T&P (temperature-pressure) valve.

If you smell gas, leave immediately and contact your gas utility before any troubleshooting.

Updated: 2026-11-16

Need help in Gas City, IN? Call 765-664-4328 or book online.

Sources12

Source links open in a new tab.

Still Have Questions?

Our experienced team is here to answer your questions and help you find the right solution.

Call nowSchedule service